C235M-B (5/99)
CM100/SCM100
Corner Mount Adapters
®
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
3500 Pelco Way,
Clovis, CA 93612-5699
USA
1. Installation and servicing should be done by qualified installation and service personnel
only.
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
2. Installation should be done according to all local and national electrical and mechanical
codes, using only approved materials.
International Customers:
Tel (1-559) 292-1981
FAX (1-559) 348-1120
3. Use only installation methods and materials capable of supporting four times the maxi-
mum weight of the equipment to be mounted.
4. Use stainless steel hardware to fasten the corner mount adapter to outdoor surfaces.
5. To prevent damage from water leakage when installing a corner mount adapter outdoors,
apply sealant around the bolt holes between the mount adapter and the mounting surface.
The product and/or manual may bear the following marks:
This symbol indicates that there are important operating and maintenance instruc-
tions in the literature accompanying this unit.
U
®
L
LISTED
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
DESCRIPTION
The CM100 corner mount adapter allows the WM2000 wall mount to be attached to the corner
of a structure. The SCM100 corner mount adapter is used in conjunction with the ST1 support
strut when additional support for the WM2000 is required. The CM100, when used with the
SCM100, will support loads up to 150 pounds (68 kg).
The CM100 and SCM100 are supplied with stainless steel hardware for attaching the WM2000
and ST1 to them. Lightweight, rugged, and easy to install, the CM100 and SCM100 are con-
structed of aluminum and have a gray polyester powder coat finish.
Models
CM100
Corner mount adapter for use with the WM2000 wall mount
SCM100
Corner mount adapter for use with the ST1 support strut in installations
requiring additional support for the WM2000 wall mount.
INSTALLATION
1. Using the CM100 corner mount adapter as a template, drill four holes into each corner surface.
2. Attach the corner mount adapter to the mounting surface with eight stainless steel fasten-
ers (not supplied). To prevent water damage if installed outdoors, seal the bolt holes with
appropriate sealant (not supplied). Apply the sealant around the bolt holes between the
mount adapter and the mounting surface.
CAUTION: Make
certain the mounting
surface is capable of
supporting the full load of the
corner mount adapter(s) and all
components to be attached.
3. Attach the WM2000 to the corner mount adapter with the provided nuts and washers and
securely tighten.
4. If you require additional support for the WM2000, install an SCM100 corner mount
adapter. Measure 14 inches (36 cm) down from the bottom of the WM2000 and mark the
wall. Center the SCM100 on the wall at the mark. Using the SCM100 as a template, drill
two holes into each corner surface.
5. Attach the corner mount adapter to the mounting surface with four stainless steel fasten-
ers (not supplied). To prevent water damage if installed outdoors, seal the bolt holes with
appropriate sealant (not supplied). Apply the sealant around the bolt holes between the
mount adapter and the mounting surface.
6. Attach the wall swivel of the ST1 support strut to the SCM100 with the provided nuts and
washers and securely tighten. Attach the ST1 clamp swivel to the WM2000 with the stain-
less steel clamp (supplied) and securely tighten.
|