TI265CS
OWNER’S MANUAL
Ti265cs Owner’s Manual
TWeeter Mounting
Threaded Retaining Nut
Mounting Baffle Area
One Piece Aluminum Housing
Installation Instructions:
1. Find a proper mounting location that is flat and has a mounting depth
clearance of roughly 15mm.
2. Cut a 43mm mounting hole in the door panel or mounting baffle.
3. Mount and secure the tweeter to the door panel or baffle using the
threaded retaining nut.
4. Connect the tweeter wires to the crossover.
Specifications
FEATURES:
• 20mm Silk Dome Tweeter
• Fully Machined Aluminum Tweeter Housing
• Poly Treated Paper Cone
• Smooth Termination Dual Roll Rubber Surround
• Powder Coated Stamped Steel Basket
• Custom Tooled Crossover Housing with Direct Wiring Connections
• Audiophile Crossover with Tweeter and Midbass Adjustments
• Continuous Play Tweeter Protection Circuitry
• Integrated Aluminum Dust Cap
• Interwoven Tinsel Leads
• High Temperature CAE/CAD Motor Structure
Note on Fully Active Crossover Systems: For the best performance we
always recommend the use of the provided passive crossovers with an
external high pass electronic crossover usually located on the amplifier
or headunit. The passive crossover design is extremely complex as
it “blends” and “smoothes” the tweeter and midrange’s response and
impedances together.
Specifications:
Ti265cs
125 watts
250 watts
4 ohms
RMS Power Handling
PEAK Power Handling
Nominal Impedance
Running the system fully active with an external electronic crossover
(instead of the passive crossovers) for the tweeter and midrange
eliminates all this smoothing and transitional circuitry. The reality is that it
almost guarantees worse performance unless the system is perfectly EQ’d
with precision crossover points. It also eliminates the tweeter protection.
Unless you are sound quality and tuning expert, using the provided
crossovers will deliver the best performance.
(Mounting and Physical Dimensions are located on the back page)
DIMENSIONS
All measurements in Millimeters
Phoenix Gold
A Division of AAMP of America™
13190 56th Court
Clearwater, Florida 33760
P: 866-788-4237
© 2012 AAMP of Florida, Inc
Designed and Engineered in the USA
LIMITED WARRANTY
Phoenix Gold warrants this product to be free of defects in materials and workmanship for a period of one (1) year from the original date of purchase. This
warranty is not transferable and applies only to the original purchaser from an authorized Phoenix Gold dealer in the United States of America only. Should
service be necessary under this warranty for any reason due to manufacturing defect or malfunction, Phoenix Gold will (at its discretion), repair or replace the
defective product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident, misuse, abuse,
product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not
cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear
and tear is not covered under warranty.
INTERNATIONAL WARRANTIES
Products purchased outside the United States of America are covered only by that country’s Authorized Phoenix Gold reseller and not by Phoenix Gold.
Consumers needing service or warranty information for these products must contact that country’s reseller for information.
|