|
Wireless USB Adapter
WNL-U553
Quick Installation Guide
Thank you for purchasing PLANET Wireless USB Adapter, WNL-
U553. In this installation guide, the illustrations included driver
and utility installing steps for Windows 2000/XP and Vista. For
more information, please also refer to the User’s manual.
Package Content
1 x WL-U553 Wireless USB Adapter
1 x USB Cable
1 x Quick Installation Guide
1 x CD-ROM (Including User’s Manual and Driver)
ꢀ
Software Installation
Please do NOT insert WNL-U553 to PC’s USB port
before installing utility.
Note
1. Insert Drivers and User’s manual CD to your CD drive, then a
welcome web will appear.
2. Please click the utility hyper link to start install driver and
utility. If the web screen doesn’t appear, please click the
“Start” and choose “Run”. When dialog box appears, enter
“E:\Utility\setup.exe”.
3. When this screen appears, please press “Next” to continue.
ꢁ
4. Installation will start copy driver and utility to your OS.
5. When this dialog box appear, please click “Continue Anyway”.
ꢂ
6. Please click “Finish” to complete the installation.
ꢃ
Hardware Installation
1. Please connect WNL-U553 to your PC’s USB port. If your PC’s
USB interface is not USB 2.0, Windows will prompt you there
is a “High-Speed USB Device Plugged into non-High-Speed
USB hub”. Please don’t worry about this and keep installing.
2. After properly connect the WNL-U553 to your PC, Windows
will detect WNL-U553 and show you this dialog box. You can
see the device name in this dialog box. If the device name is
correct, please press ”Next” to the driver installation.
ꢄ
3. Windows may show you this driver is not passed Windows
Logo test, please select “Continue Anyway” to continue.
4. After the driver installation complete appears. Please click
“Finish”.
ꢅ
Configure WNL-U553 wireless settings
In Windows XP / 2000, when wireless card installed, the built-
in wireless utility will take control your wireless card. You may
need to disable this utility when you would like to use WNL-
U553 utility.
1. Please double click the wireless utility icon
on the bottom-
right of desktop. Then you will see the Windows Zero Config
Service dialog box, please click “Advanced” button. When
the below screen appear, please disable “Use Windows to
configure my wireless network settings” and press “OK”.
10
2. Please double click the icon
again. The WNL-U553 utility
will appear. Please select “Site Survey” option. Select the AP
from the AP list and press “Connect” to connect the selected
AP. If the AP you would like to connect is not in the list,
please press “Refresh” to search again.
3. For more detail settings, please refer to the User’s manual to
configure.
11
Further Configuration
For detail configuration, please check user’s manual on the
bundled CD.
If you have any other questions, please contact the dealer
where you purchased this product or you can contact PLANET
directly at the following email address: [email protected]w
12
|