2013
Reaper
SubwooferS
REP-12
Enclosure Dimensions
Included in this manual are a number of different enclosure sugges-
tions. These are by no means the only enclosures to use, but they
provide a starting point to determine the correct enclosure for your
needs many factors must be addressed (amount of power, vehicle,
placement, crossovers, etc) Therefore, as always, SPL recommends
that your subwoofer be installed by an authorized SPL dealer.
Enclosure Construction
All enclosures should be made of .75” (3/4”) material only. When pos-
sible, make the baffle 1.5” (1 ½) thick and add .75” (3/4”) to the depth
of the enclosure to compensate. All volumes INCLUDE vent/port and
subwoofer displacements. DO NOT change the volume unless you
plan on adding a substantial amount of bracing. For added per-
formance, applying a coat of fiberglass resin to the interior walls will
greatly improve sealing the enclosure. Adding a thin layer of poly-fill
will improve response by smoothing out reflections within the enclo-
sure.
Rep12
seaLed
mInImum
optImum
poRted
1.0 cu Ft
1.25 cu Ft
mInImum
poRt WxL
F3 hz
1.5 cu Ft
4Inch x 7Inch
42.13
optImum
poRt WxL
F3 hz
2.0 cu Ft
4Inch x 10.5Inch
35.68
Download from Wwwww.Swom.Paonuwalse.croAmc. AolluMsatniuka.lcs oSemarch And Download.
|