Package Contents
Warning Before Installation
1
The product model shown in this QIG is TL-SC3230N, as an example.
Do not keep the Camera exposed
to direct sunlight.
It is recommended to mount the Camera where objects often pass,
and the direction towards the door or passage is much better, see
the illustration below:
Quick Installation Guide
Do not place the Camera in high
humidity environments such as
in a kitchen.
Power Adapter
Megapixel Surveillance Camera
TL-SC3230N
Mounting Bracket
Wireless N Megapixel Surveillance Camera
Megapixel Surveillance Camera
Wireless
N
Megapixel Surveillance Camera
Do not place the Camera where
there are high temperatures
such as near an oven.
TL-SC3230/TL-SC3230N
QIG
Ethernet Cable
Resource CD
(*The pictures are for reference only.)
System Requirement
The following operating systems are supported:
Do not place the Camera near
devices that emit radio waves,
such as mobile phones.
Windows 2000
Windows Vista
Windows 2003
Windows 7
Windows XP
The following browsers are supported:
Internet Explorer 8 or higher
Safari
Firefox
Chrome
MODEL NO. TL-SC3230/TL-SC3230N
(*Internet Explore Browser is recommended.)
Physical Description
Hardware Connection
2
3
*
Antenna
Connect the LAN port on Camera to the LAN Port of your
router or switch with an Ethernet cable.
Built-in Microphone
Micro-SD Card Slot
Lens & Focus Ring
Connect the power adapter cord to the Power jack.
Plug the power adapter into the power outlet.
Power/Wireless LED
LAN LED
Audio Output Jack
RESET Button
WPS
Power Jack
LAN Port
LED
Status
Oꢁ
Description
The camera is powered oꢁ.
Note:
Before proceeding, conꢀrm that your PC is connected to your
Router and can access the Internet.
Power/
Wireless
LED
The camera ꢀnishes boot-up and is ready to serve. Power on
the camera, the LED will light up and then go oꢁ to booting
process. After keeping oꢁ for several seconds, the LED will be
solid orange.
Solid Orange
Make sure that your Router’s DHCP feature is enabled. If not,
please refer to your Router’s instruction to enable it.
*
Flash Orange
The camera has been connected to a wireless network.
No cable is linked to the camera.
Solid Green
Flash Green
LAN LED
Ethernet Cable
Ethernet Cable
Data is being transmitted or received.
Button
Description
While the camera is ready, press RESET button for at least 5 seconds and
release it. The camera will be restored to default settings and reboot
again.
RESET Button
* The Antenna and Flash Orange status are for TL-SC3230N only.
7106504101
|