Targus Mouse AMB09US User Manual

User Guide  
 
Targus Bluetooth Comfort Laser Mouse  
Installing the Batteries  
1. Remove the battery cover from the top of the mouse by using the notch  
on the back. Carefully lift the cover up as shown in the diagram.  
2. Remove the battery safety clip by squeezing the center of the clip and  
sliding it back, towards the rear of the mouse. Lift up and rotate the clip  
out of the way.  
NOTE: THE BATTERY SAFETY CLIP WILL NEED TO BE IN THE SECURE, LOCKED POSITION  
BEFORE THE BATTERY COVER CAN BE PUT BACK IN PLACE.  
3
 
Targus Bluetooth Comfort Laser Mouse  
3. Slide and lift to remove the battery holder as shown.  
4. Insert the two AA batteries, making sure that the positive (+) and  
negative (-) ends of each battery match the polarity indicators inside  
the battery compartment.  
4
 
Targus Bluetooth Comfort Laser Mouse  
5. Replace the battery safety clip and by sliding it forward until it clicks into  
place and then replace the battery cover.  
6. Turn on the mouse by pressing the power On/Off button on the bottom  
of the mouse. Hold for 3 seconds and then release.  
Power button  
5
 
Targus Bluetooth Comfort Laser Mouse  
Power On:  
Press and hold the power button for 3 seconds and then release.  
The battery life indicator will briefly light up showing the current power level of the  
batteries.  
Power Off:  
Press and hold the power button for 3 seconds and then release.  
The battery life indicator will briefly light up and then fade out.  
Battery Check:  
After the mouse is turned on, quickly press and release the power button. The  
battery life indicator will light up showing the current power level of the batteries.  
Initial Mouse Setup  
Enable Discovery mode:  
The mouse will go into pairing mode automatically after it is powered on. The 1st  
and 3rd LEDs will flash alternately for 60 seconds; this indicates that the pairing  
sequence is in operation. Once the connection is established, the 1st and 3rd LED  
lights will light up steadily for 3 seconds.  
1st LED  
3rd LED  
If the connection is not established by the end of 60 seconds, the mouse will go  
into sleep mode. Click on any mouse button to exit from sleep mode. The pairing  
sequence will re-start automatically.  
6
 
Targus Bluetooth Comfort Laser Mouse  
Power Saving mode:  
After an extended period of time, if the mouse is not used, it will automatically enter  
power saving mode to conserve power and increase battery life. Click on any mouse  
button to resume the normal operation. The mouse may take a few seconds to  
reconnect with your computer.  
Battery Life Indicator  
3 LEDs lit  
2 LEDs lit  
1 LED lit  
Full power  
Half power  
Low power  
NOTE: WHEN THE FIRST LIGHT IS BLINKING, PLEASE REPLACE THE BATTERIES  
Power Management  
To extend the life of your battery, turn off the mouse while travelling or  
when you’re not using it.  
7
 
Targus Bluetooth Comfort Laser Mouse  
Initial Configuration  
Before you can begin using your Bluetooth® mouse, you will first need to  
perform some initial setup steps.  
NOTE: PLEASE USE THE LATEST BLUETOOTH DEVICE DRIVER. INSTRUCTION SCREENS MIGHT VARY  
DEPENDING ON THE VERSION OF YOUR BLUETOOTH DEVICE DRIVER.  
8
 
Targus Bluetooth Comfort Laser Mouse  
Connecting with Bluetooth Software:  
WIDCOMM or Microsoft  
(Windows XP & Windows Vista)  
1. Go to the Bluetooth Places icon located on your desktop or in the system tray and  
double click, then click Add a Bluetooth Device.  
(Windows XP)  
(Windows Vista)  
2. The Bluetooth Wizard screen will prompt. Please follow the onscreen instructions.  
(Windows XP)  
(Windows Vista)  
9
 
Targus Bluetooth Comfort Laser Mouse  
3. Power on the mouse and it will automactically go into discovery mode. Click Next  
to continue pairing and the computer will search for the mouse.  
(Windows XP)  
(Windows Vista)  
4. The confirmation window will appear after the computer finishes detecting  
the Bluetooth devices. Select the Bluetooth Wireless Mouse and click Next to  
continue. (There may be one or more different Bluetooth devices detected.) If the  
mouse is not detected, please make sure the power is on and in discovery mode.  
Press Search Again to re-pair the device.  
(Windows XP)  
(Windows Vista)  
10  
 
Targus Bluetooth Comfort Laser Mouse  
5. After selecting the correct device, the computer will finish establishing the  
connection. Please wait until the setup is completed.  
(Windows XP)  
(Windows Vista)  
11  
 
Targus Bluetooth Comfort Laser Mouse  
Connecting with Bluetooth Software:  
TOSHIBA  
(Windows Vista)  
1. Double click on the Bluetooth Manager icon in the system tray, and then click  
Add New Connection.  
2. Power on the mouse and it will automactically go into discovery mode. Click Next  
to continue pairing and the computer will search for the mouse.  
12  
 
Targus Bluetooth Comfort Laser Mouse  
3. The computer will now search for the Bluetooth mouse and other Bluetooth devices.  
Please wait until the search is completed. Choose the device you wish to connect.  
There may be more than one Bluetooth device detected. Select Bluetooth Wireless  
Mouse and click Next to continue. If the mouse is not detected, please make sure the  
mouse is in discovery mode and click Refresh.  
4. The computer will begin connecting with the device.  
13  
 
Targus Bluetooth Comfort Laser Mouse  
5. The connection is established and setup is complete. The device is ready to use. If  
the connection is not successful, please click Back and search the device again.You  
can continue to add other Bluetooth devices or close the window.  
14  
 
Targus Bluetooth Comfort Laser Mouse  
Bluetooth Software: Mac  
1. Go to the Bluetooth icon located on your desktop or in the system bar and click the  
icon to begin setup. Select “Turn Bluetooth On” to activate the Bluetooth function  
on your Mac.  
2. Scroll down the list and select “Set up Bluetooth Device...”  
3.The Bluetooth Setup Assistant will begin. Please follow the on-screen instructions.  
15  
 
Targus Bluetooth Comfort Laser Mouse  
4. Select “mouse” and click continue to proceed with setup.Your mouse will need to be  
in “discovery” mode to connect. Power on the mouse and it will automactically go  
into discovery mode.  
5. Your computer will begin to search for the mouse. Once the mouse is found, it will  
show up in the list. Highlight your mouse and press continue.  
16  
 
Targus Bluetooth Comfort Laser Mouse  
6. The Bluetooth mouse will now begin pairing. Click continue to proceed.  
7. Congratulations.Your Bluetooth mouse is setup and ready to use.You can choose to  
setup another device or click Quit to exit setup.  
17  
 
Targus Bluetooth Comfort Laser Mouse  
Programming Your Mouse  
(Windows Only)  
To access the advanced scroll wheel features you will need to download  
and install the software driver. This can be downloaded from the following  
location:  
Visit www.targus.com to download and install the driver.  
Once installation is complete, open the driver software and select the  
desired setting for the scroll-wheel button. Close the driver software  
application and you’re ready to go. Activate your selected feature by  
pressing down on the scroll wheel.  
18  
 
Targus Bluetooth Comfort Laser Mouse  
Troubleshooting  
The mouse is not working.  
• Make sure that the polarity of the batteries is correct. The positive (+) and  
negative (-) ends of each battery must match the positive (+) and negative (-)  
connections in the battery housing.  
• Make sure the batteries are charged. Recharge or replace if necessary.  
• Verify that the computer is Bluetooth enabled.  
• Verify that the device drivers are installed:  
1. Click Start/ Settings/ Control Panel/ System/ Hardware/ Device Manager  
2. Check under “Bluetooth Devices” that a “Soft-Touch Bluetooth” is installed  
• Paired devices are always displayed in My Bluetooth Places, even if the mouse is  
out of range or not powered up.  
19  
 
Targus Bluetooth Comfort Laser Mouse  
Technical Support  
For technical questions, please visit:  
US  
Australia  
Telephone: 1800-641-645  
New Zealand  
Telephone: 0800-633-222  
Product Registration  
Targus recommends that you register your Targus accessory shortly after purchasing  
it. Go to:  
You will need to provide your full name, email address, country of residence and  
product information.  
Warranty  
Targus warrants this product to be free from defects in materials and workmanship  
for one year. If your Targus accessory is found to be defective within that time, we will  
promptly repair or replace it. This warranty does not cover accidental damage, wear  
and tear, or consequential or incidental loss. Under no conditions is Targus liable for  
loss of, or damage to devices; nor loss of, or damage to, programs, records, or data;  
nor any consequential or incidental damages, even if Targus has been informed of  
their possibility. This warranty does not affect your statutory rights.  
20  
 
Targus Bluetooth Comfort Laser Mouse  
Regulatory Compliance  
This device complies with Part 15 of the FCC Rules and Industrial Canada RSS-210.  
Operation is subject to the following two conditions: (1) This device may not cause  
harmful interference, and (2) This device must accept any interference received,  
including interference that may cause undesired operation.  
Compliance with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to  
Laser Notice No. 50, dated June 24, 2007  
Respect de la réglementation  
Cet appareil est conforme à la section 15 des règlements de la FCC (Federal  
Communication Commission) et à la norme CNR-210 du Canada.  
Son utilisation est soumise aux deux conditions suivantes : (1) Cet appareil ne peut  
provoquer de brouillage préjudiciable.(2) Cet appareil doit absorber toute interférence  
réceptionnée, même si cela provoque des effets indésirables sur son fonctionnement.  
21  
 
Targus Bluetooth Comfort Laser Mouse  
FCC Statement  
Tested to Comply  
This equipment has been tested and found to comply with the limits of a Class B  
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to  
provide reasonable protection against harmful interference in a residential installation.  
This equipment generates, uses, and can radiate radio frequency energy and if not  
installed and used in accordance with the instructions, may cause harmful interference  
to radio communications. However, there is no guarantee that interference will not  
occur in a particular installation. If this equipment does cause harmful interference to  
radio or television reception, which can be determined by turning the equipment off  
and on, the user is encouraged to try to correct the interference by one or more of  
the following measures:  
• Reorient or relocate the receiving antenna;  
• Increase the separation between the equipment and receiver;  
• Connect the equipment into an outlet on a circuit different from that to which the  
receiver is connected;  
• Consult the dealer or an experienced radio/TV technician for help.  
Changes or modifications not authorized by the party responsible for compliance  
could void the user’s authority to operate this product.  
Declaration of Conformity  
Hereby, Targus, declares that this device is in compliance with the essential  
requirements and other relevant provisions of Directive 1999/5/EC.  
Microsoft, Windows, and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the  
United States and/or other countries. All trademarks and registered trademarks are the property of their respective owners.  
All rights reserved. Features and specifications are subject to change without notice. © 2009. Targus Group International,  
Inc. and Targus, Inc., Anaheim, CA 92806 USA  
22  
 
Targus Bluetooth Comfort Laser Mouse  
CAUTION  
LASER RADIATION. DO NOT STARE INTO THE BEAM OR VIEW DIRECTLY WITH  
OPTICAL INSTRUMENTS. CLASS I LASER PRODUCT.  
NEVER POINT A LASER BEAM INTO A PERSON’S EYES OR VIEW A LASER BEAM  
DIRECTLY, AS PROLONGED EXPOSURE CAN BE HAZARDOUS TO THE EYES.  
MOMENTARY EXPOSURE FROM A LASER POINTER, SUCH AS AN INADVERTENT  
SWEEP OF THE LIGHT ACROSS A PERSON’S EYES, MAY CAUSE TEMPORARY  
FLASH BLINDNESS SIMILAR TO THE EFFECT OF A CAMERA FLASH BULB.  
ALTHOUGH THIS CONDITION IS TEMPORARY, IT CAN BECOME MORE  
DANGEROUS IF THE EXPOSED PERSON IS ENGAGED IN A VISION-CRITICAL  
ACTIVITY SUCH AS DRIVING.  
23  
 
1
YEAR LIMITED WARRANTY: We pride ourselves  
on the quality of our products. For complete warranty  
details and a list of our worldwide offices, please visit  
subject to change without notice. Microsoft, Windows  
and Windows Vista are registered trademarks or  
trademarks of Microsoft Corporation in the United  
States and/or other countries. Mac is a trademark of  
Apple Inc., registered in the U.S. and other countries.  
N2953  
Logitech is  
a
registered trademark of Logitech  
International in the United States and other countries.  
The Bluetooth word mark and logos are owned by  
the Bluetooth SIG, Inc. and any use of such marks by  
Targus is under license. All trademarks and registered  
trademarks are the property of their respective owners.  
©2009 Targus Group International, Inc.  
QD ID : B012764  
 

Tekkeon Battery Charger IA1000 User Manual
Texas Instruments Computer Hardware SCAU020 User Manual
TIMEX Weather Products Indoor Furnishings GL 05 User Manual
Transition Networks TV Converter Box MGE PSW SX 01 User Manual
TRENDnet Network Router TW100 BRV324 User Manual
Tripp Lite Surge Protector Rackmount Power Strips and Isobar Rackmount Surge Suppressors Line Noise Filters User Manual
Uniden Two Way Radio UH 099 User Manual
Verilux Indoor Furnishings VL01 User Manual
Vizio Car Satellite TV System E601i A3 User Manual
Weber Hot Beverage Maker 96811 User Manual