Thermador Ventilation Hood Thermador User Manual

®
CARE AND USE FOR  
ISLAND HOODS  
(Turn Book Over for Installation  
Instructions)  
READ AND SAVE THESE INSTRUCTIONS  
HNI  
O
O
HTNI  
Model #  
Serial #  
5551 McFadden Avenue, Huntington Beach, CA 92649 • 800/735-4328  
RO#8605 • 35-05-274A • ©BSH Home Appliance Corporation, 1998 • Litho in U. S. A. 4/00  
Download from Www.Somanuals.cPoamg.eA1ll Manuals Search And Download.  
LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES  
AVERTISSEMENT - POUR  
5. Utiliser toujours les batteries  
RÉDUIRE LE RISQUE  
de cuisine et les ustensiles  
D’INCENDIE, DE CHOC  
appropriés pour le type et la  
ÉLECTRIQUE, OU DE LA  
quantité de la nourriture  
BLESSURE AUX PERSONNES,  
ayant préparée.  
OBSERVER LE SUIVANT:  
AVERTISSEMENT: - POUR  
RÉDUIRE LE RISQUE DE  
BLESSURE AUX PERSONNES  
DANS L’ÉVÉNEMENT D’UN FEU  
DE GRAISSE DU SOMMET DE  
LA CUISINIÈRE, OBSERVER  
LES SUIVANTS:  
ATTENTION: SEULEMENT POUR  
L’UTILISATION D’AÉRATION. NE  
PAS L’UTILISER POUR ÉPUISER  
LA VAPEUR OU LES MATIÈRES  
EXPLOSIVESOUDANGEREUSES.  
1. Utiliser cet appareil seulement  
dans la manière destinée par  
a) ÉTOUFFER LES FLAMMES  
avec un couvercle ajusté,  
une tôle du biscuit ou un  
plateau métallique, puis  
fermer le bec. SOYEZ  
le fabricant. Si vous avez des  
questions, contacter le  
fabricant(800-735-4328).  
2. Avant l’entretien ou le  
nettoyage de l’appareil, couper  
le courant au tableau de  
service, et fermer à clef.  
CERTAIN D’EMPÊCHER LES  
BRÛLURES. Si les flammes  
ne s’éteindront pas  
immédiatement, ÉVACUER  
ET APPELER LE SERVICE  
DES INCENDIES.  
AVERTISSEMENT - POUR  
RÉDUIRE LE RISQUE D’UN FEU  
DE GRAISSE DU SOMMET DE LA  
CUISINIÈRE:  
b) NE JAMAIS RAMASSER UNE  
CASSEROLE EN FLAMMES -  
Vous pouvez être brûlé.  
1. Garder le ventilateur, les  
filtres et les surfaces chargées  
de la graisse propres.  
c) NE PAS UTILISER DE L’EAU,  
y compris les torchons  
mouillés ou les serviettes -  
une explosion violente  
résultera.  
2. Toujours mettre le capot EN  
MARCHE en cuisinant à la  
haute chaleur.  
d) Utiliser un extincteur  
SEULEMENT si:  
3. Utiliser les hauts  
1) Vous savez que vous  
avez un extincteur de Classe  
ABC et vous. savez déjà  
comment le faire fonctionner.  
2) Le feu est petit et est  
contenu dans la région où il  
a commencé.  
positionnements du cuisinière  
sur la cuisinière seulement  
quand c’est nécessaire.  
Chauffer l’huile lentement sur  
un positionnement bas à  
moyen.  
3) Le service des  
incendies est appelé.  
4) Vous pouvez  
4. Ne pas laisser la cuisinière  
sans surveillance pendant la  
cuisson.  
combattre le feu avec votre  
dos à une sortie.  
Download from Www.Somanuals.cPoamg.eA3ll Manuals Search And Download.  
CONTROL PANEL  
MODELS: HNI, HTNI ELECTRONIC TOUCH CONTROLS  
A. Motor OFF button  
Circuit Self-test  
B. ON button and motor speed  
selection button 1, 2, 3, 1,....  
C. Speed 1LED  
The control allows the user to  
perform a self-test to check the  
correct function of the hood.  
The self test is activated by pressing  
the A and B keys simultaneously  
for 3 seconds.  
D. Speed 2 LED  
E. Speed 3 LED  
F. Timer LED  
G. Timer.  
If the motor is off while the  
timer is pressed the motor will  
run at speed 3 for 20 minutes  
then stop.  
If the motor is running when the  
timer key is pressed the motor  
will continue to run for 10  
minutes. After 10 minutes the  
motor will stop.  
The self-test procedure order is:  
1. Four LED’s switch on.  
2. Four LED’s switch off.  
3. Blower runs at speed 1.  
4. Blower runs at speed 2.  
5. Blower runs at speed 3.  
6. Blower off.  
7. Lights switch on.  
8. Lights dim (only for model  
HTNI).  
Pressing the timer or speed  
button while the Timer LED is  
on will disable the timed mode.  
H. Light ON/OFF button.  
I. Dim Light ON/OFF button (only  
for model HTNI).  
9. Lights turn off.  
10. Beep signals end of self-test.  
OPERATING  
INSTRUCTIONS - HOOD  
The blower should be turned on for  
10 minutes before cooking in order  
to establish air currents through the  
hood. This will improve the capture  
and removal of heat, smoke,  
moisture, grease and cooking odors.  
Use the low speeds for normal use  
and the higher speeds for strong  
odors or fumes.  
Fig. 1  
Grease Filter Saturation LED  
The speed 2 LED in Figure 1 in  
is marked with an F. This LED will  
flash to remind you when the grease  
filter needs to be cleaned after 40  
hours use. Follow the instructions  
for cleaning filters in thisFollow the  
instructions for cleaning filters in  
this booklet. Once the grease  
filters have been cleaned, reset the  
display by pressing button A for 3  
seconds until you hear the signal  
(beep).  
Drafts across the range or cooktop  
will reduce the effectiveness of the  
hood. Such drafts should be pre-  
vented when possible.  
Page 4  
 
FILTERS  
CLEANING  
INSTRUCTIONS  
Be sure lights are cool  
before cleaning the hood.  
The metal grease filters are made of  
anodized aluminum and are long  
lasting.  
To Clean Filter/s  
To Remove The Metal Grease  
Filter/s  
It is recommended that the  
filters be washed at least once a  
month; they can be washed by  
hand or in the dishwasher.  
Drain water through holes and  
along filter edges and allow to  
dry thoroughly before replacing  
it.  
Turn blower and lights off.  
For Models HNI, HTNI  
Push each handle in the  
direction of the arrows as shown  
in Fig. 2.  
To Replace The Metal Grease  
Filter/s  
To Clean Hood Surface  
For general care, wipe the  
outside of the stainless steel,  
white, black or glass hood with  
sudsy water or household  
cleaners such as Fantastic® or  
Formula 409®, rinse well and dry  
with clean soft cloth to avoid  
water marks.  
Reverse procedure.  
Wipe and dry brushed stainless  
steel in the same direction as the  
grain.  
Fig. 2  
Do not use abrasive products.  
To remove finger prints and give  
added shine use spray cleaners  
such as Stainless Steel Magic®  
and Shimmer®  
Download from Www.Somanuals.cPoamg.eA5ll Manuals Search And Download.  
LIGHTS  
NOTE: Turn blower and lights  
off. Make sure the lights are  
cool. If new lights do not operate:  
verify lights are inserted correctly  
before calling service.  
ReplaceLightsForModelHTNI  
(Fig. 3)  
Remove the damaged light and  
replace with a new halogen light  
Type MR16, 12 Volt, 20 Watt  
maximum.  
When installing the new light be  
sure that the two prongs of the  
light fit perfectly into the two  
sockets of the lightholder. Press  
in firmly.  
Fig. 3  
Replace Lights For Model HNI  
(Fig. 4)  
Remove lens cover by removing  
screw and pulling cover down.  
Pull out flourescent tube and  
replace with Philips Type  
PL-S 9 Watt maximum.  
Replace cover and secure with  
screw.  
Fig. 4  
Page 6  
 
®
Thermador Hood Warranty  
FULL ONE YEAR WARRANTY  
Covers one year from date of installation, or date of occupancy on a new, or previously  
unoccupied dwelling. Save your dated receipt or other evidence of installation/  
occupancy date.  
Thermador Will Pay For:  
All repair labor and replacement parts found to be defective due to materials and  
workmanship.  
Service must be provided by a Factory Authorized Service Agency, during normal  
working hours. For a Service Agency nearest you, please call 800/735-4328.  
Thermador Will Not Pay For:  
1.  
2.  
Service by an unauthorized agency. Damage or repairs due to service by an  
unauthorized agency or the use of unauthorized parts.  
Service visits to:  
• Teach you how to use the appliance.  
• Correct defects or repairs due to improper installation. You are responsible  
for providing electrical wiring and other connecting facilities.  
• Reset circuit breakers or replace home fuses.  
• Correct damage caused from accident, alteration, misuse, abuse, improper  
installation or installation not in accordance with local electrical codes or  
plumbing codes, or improper storage of the appliance.  
Service labor during limited warranty period.  
3.  
4.  
Travel fees and associated charges incurred when the product is installed in a  
location with limited or restricted access (i.e. airplane flights, ferry charges,  
isolated geographic regions).  
5.  
Repairs due to other than normal home use.  
This warranty applies to appliances used in residential applications; it does not cover  
their use in commercial installations. The warranty is for products purchased and  
retained in the 50 states of the U. S. A., the District of Columbia and Canada. Should  
the appliance be sold by the original purchaser during the warranty period, the new  
owner continues to be protected until the expiration date of the original purchaser's  
warranty period. Products for use in Canada must be purchased through the Canadian  
distribution channel to ensure regulatory compliance and warranty coverage. This  
warranty gives you specific legal rights. You may also have other rights which vary  
from state to state.  
HOW TO OBTAIN SERVICE  
Contact the Factory Authorized Service Agent in your area.  
Contact the Dealership where you purchased the appliance.  
Call the Thermador Customer Support Call Center at 800-735-4328.  
Write to us at: Thermador 5551 McFadden Avenue, Hunington Beach, CA 92649.  
Download from Www.Somanuals.cPoamg.eA7ll Manuals Search And Download.  
Page 8  
 

TC electronic SDN BHD Guitar NDY 1 User Manual
Technics Stereo System SL 1200MK2PK User Manual
Technika Stereo System MC 429ID User Manual
Teledyne Oxygen Equipment 307WA User Manual
Texas Instruments Stereo Amplifier THS4141 User Manual
Toshiba DVD VCR Combo MW24FN1 User Manual
TP Link Landscape Lighting CPE210 User Manual
Verizon Cell Phone C751 User Manual
Vermont Casting Indoor Fireplace 2547CE User Manual
Viking Cooktop 033111 User Manual