Thermaltake Power Supply 350W User Manual

PurepowerTM Series  
Unmatched  
Performance  
C
Copyright  
2009 Thermaltake Technology Co., Ltd. All Rights Reserved.  
All trademarks are the property of their respective owners.  
Reproduction in whole or in part without written permission is prohibited.  
 
PurepowerTM Series  
PurepowerTM Series  
1. Warnings and Caution  
2. Components Check  
1. Do not unplug the AC power cord when the power supply is in  
use. Doing so may cause damage to your components.  
2. Do not place the power supply in a high humidity and/or  
temperature environment.  
- Power supply unit  
- User manual  
3. High voltages exist in the power supply. Do not open the  
power supply case unless you are an authorized service  
technician or electrician. Doing so will void the warranty.  
4. PSU should be powered by the source indicated on the rating  
label.  
- AC power cord  
- Mounting screws  
5. All warranties and guarantees will be voided, if failure to  
comply with any of the warnings and cautions covered in this  
manual.  
01  
02  
 
PurepowerTM Series  
PurepowerTM Series  
3. Power Connector Introduction  
4. Installation Steps  
Cable  
Note: Make sure that your system is turned off and unplugged.  
Disconnect the AC power cord from your old power supply.  
P/N Model  
20+4pin Main 4pin +12V CPU  
SATA  
Peripheral  
Connector  
Floppy  
6pin PCI-E  
Connector  
Connector  
1
Connector  
1
Connector  
Connector  
W0330 550W  
W0329 450W  
W0328 350W  
4
2
2
6
5
5
2
1
1
1
1
0
1
1
1
1
1. Open your computer case; please refer to the direction in your  
case manual.  
2. Install the PSU into the case with the four screws provided.  
3. Connect the 24 pin Main Power Connector to your  
motherboard and peripheral. If your motherboard uses a 20-pin  
MODELS  
Connector Type  
Connectors & Cable length  
1 x 24pin Main connector  
20+4pin  
W0330  
W0329  
W0328  
(400mm)  
1 x ATX 12V 4pin connector  
(400mm)  
connector, detach the 4-pin attachment on the 24-pin connector.  
Note: The detachable 4-pin section cannot be used in place of a 4-pin +12V  
connector.  
ATX 12V 4pin  
3 x Peripheral, 1 x FDD connectors  
(400mm + 150mm + 150mm + 150mm)  
3 x Peripheral, 1 x FDD connectors  
(400mm + 150mm + 150mm + 150mm)  
W0330  
W0329  
W0328  
W0330  
4. Connect the 8-pin or 4-pin connector for the CPUs.  
5. Connect other peripheral power connectors to devices such as  
hard drives, optical drives, etc.  
3 x Peripheral, 1 x FDD connectors  
(400mm + 150mm + 150mm + 150mm)  
2 x Peripheral connectors  
Molex & FDD  
(400mm + 150mm)  
3 x Peripheral connectors  
6. Close your computer case and connect the AC power cord to  
the power supply AC inlet.  
(400mm + 150mm + 150mm)  
2 x Peripheral, 1 x FDD connectors  
(400mm + 150mm + 150mm)  
2 x SATA connectors  
(400mm +150mm)  
2 x SATA connectors  
(400mm +150mm)  
SATA  
2 x SATA connectors  
(400mm + 150mm)  
W0329  
W0328  
SATA  
1 x 6pin PCI-E connectors  
(400mm)  
W0330  
W0329  
PCI-E 6pin  
03  
04  
 
PurepowerTM Series  
PurepowerTM Series  
5. Product Features  
6. Output Specification  
INPUT VOLTAGE: 115V/230V, FREQUENCY:47HZ-63HZ  
OUTPUT  
PEAK  
MODEL DC OUTPUT +3.3V +5V +12V1 +12V2 -12V +5Vsb  
POWER POWER  
MAX Current 18A  
28A  
18A  
1.0A 1.0A  
15A 15A 0.3A 2.5A  
0A 0A  
10A 0.3A 2.5A  
0.5A 0.5A 0.5A 0A 0A  
18A 0.3A 2.0A  
W0330  
W0329  
W0328  
405W  
355W  
255W  
550W  
450W  
350W  
MIN Current  
MAX Current  
MIN Current  
2A  
0A 0A  
0.3A  
21A  
18A  
- Ultra-efficient circuitry design.  
0.3A 0.5A 0.5A 0.5A  
18A 10A  
- Near-silent thermal engineering.  
MAX Current 19A  
MIN Current  
- Stable true power output.  
0.3A  
- Intel ATX 12V 2.2 Compatible  
- Dual +12V output circuit provides outstanding steady output  
for system.  
- Adjustable AC input (115V/230V) for different country.  
- Intel & AMD CPU compliance.  
7. Total Protection  
- Compatible with latest PCI-Express (450W / 550W).  
- Super quiet and stable 8cm fan.  
Over Voltage Protection  
- High reliability: MTBF>100,000 hours.  
- Protections: Over Power, Over Voltage, and Short-Circuit  
protection.  
Voltage Source  
+3.3V  
Protection Point  
4.5V Max.  
+5V  
7.0V Max.  
- Safety / EMI Approvals: UL and FCC certified.  
+12V  
15.6V Max.  
Short Circuit Protection  
A short circuit placed between dc return and output rail (Approximately  
0.03ohm) shall cause no damage to power supply and the main output  
shall shut down and latch off, but the 5Vsb might recovery automatically.  
05  
06  
 

Targus Network Card ACH81US User Manual
Teledyne Oxygen Equipment 3010TBC User Manual
Texas Instruments Switch HPL D SLLU064A User Manual
Tiger Games 36287 User Manual
Topcom Telephone DIABLO 103 User Manual
Toshiba Power Supply 20kVA User Manual
Toshiba Projector 3LCD User Manual
Troy Bilt Tiller 12077 User Manual
Verilux Indoor Furnishings VP04 User Manual
Video Products Computer Hardware SE DVI 8 LC User Manual