RH767 RFID Handheld Reader
Unitech is a member of the Oracle Embedded Software
Licensing Program.
Quick Reference Guide
400558G Rev. B
Copyright 2008 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Front View
Status Indicator.
Power Button.
1
2
3
4
5
6
7
LCD Touch-screen.
Microphone.
Alpha Mode Indicator.
Right Scanner Trigger Button.
Keypad.
CopDyrigohwt 2n00l8ouanidtecfhrEolemctroWnicswCwo.,.LStdo. Amll raignhtsuraeslesrv.ecdo. umnit.ecAh ilslaMreagisnteureadltsradSemeaarkrocf huniAtecnhdEleDctroonwicsnCloo.,aLdtd..
Back View
Stylus.
8
9
13 Bar Code Scanner Trigger.
14 Battery Compartment.
15 Strap Hook.
Bar Code Scanner Window.
10 Infrared (IR) Port.
Left Scanner Trigger Button.
11
16 RFID Antenna.
12 Reset Button.
Bottom View
17 Battery Pack.
19 PCMCIA Slot.
18 Universal Connector.
Copyright 2008 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Installing the Battery
The RH767 is embedded with a Backup Battery cell to prevent data loss when the
main Battery diconnects from the device. However, the Backup Battery will only
store data for a maximum of 72 hours.
1. Open the Battery Compartment by sliding the tabs in the direction as shown
below:
2. Locate the Backup Battery Switch and turn it to the ON position as shown below:
Backup Battery & Grip Battery Switch
3. Align the Battery Contacts with the Battery Compartment Contacts as shown
below:
Battery Contacts
CopDyrigohwt 2n00l8ouanidtecfhrEolemctroWnicswCwo.,.LStdo. Amll raignhtsuraeslesrv.ecdo. umnit.ecAh ilslaMreagisnteureadltsradSemeaarkrocf huniAtecnhdEleDctroonwicsnCloo.,aLdtd..
4. Place the Battery Pack into the Battery Compartment and press the battery
securely into place.
5. Replace the Battery Compartment cover, push down the tabs and slide them back
into the lock position as shown below:
Charging the Battery
1. Connect the Synchronization Power Cable connector to the RH767 (1).
2. Plug the AC Adapter cable into the USB Connector's power jack (2).
3. Connect the AC Adapter into an electrical outlet (3).
Copyright 2008 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Keypads and Function Buttons
Key
Main Function
Power button.
Escape key.
Backspace key.
Function key.
Tab key.
Enter key.
4 way cursor keys, brightness +-.
Alpha key, toggle between numeric and alphabetic entry
modes.
Numbers keys, characters keys.
~
Punctuation key.
Using Function keys
Key
Function
Toggle Display Backlight.
Toggle Keypad LED Backlight.
Increase screen brightness.
[FUNC]+
[FUNC]+
[FUNC]+
Decrease screen brightness.
[FUNC]+
CopDyrigohwt 2n00l8ouanidtecfhrEolemctroWnicswCwo.,.LStdo. Amll raignhtsuraeslesrv.ecdo. umnit.ecAh ilslaMreagisnteureadltsradSemeaarkrocf huniAtecnhdEleDctroonwicsnCloo.,aLdtd..
Toggle to Alpha Mode and CAPS
Numeric Mode is the RH767's default function. In Alpha Mode, CAPS mode is the
d e f a u l t c o n d i t i o n . U s e a l p h a a n d F u n c t o t o g g l e i n t o C A P S .
Key
Alpha OFF
FUNC UP
ESC
Alpha ON
FUNC DOWN FUNC UP
FUNC DOWN
ESC
ESC
ESC
ESC
Backspace Backspace Backspace
Backspace
Backspace
Enter
1/F1/a
2/F2/b
3/F3/c
TAB/d
4/F4/e
5/F5/f
6/F6/g
+/^/h
%/BL/i
7/F7/j
8/F8/k
9/F9/l
-/_/m
./;/n
Enter
1
2
3
TAB
4
5
6
+
%
7
8
9
-
.
@
Enter
F1
F2
F3
`
F4
F5
F6
Enter
Enter
A
B
C
D
E
a
b
c
d
e
f
g
h
i
j
k
l
m
n
o
p
q
r
F
G
H
I
J
K
^
Backlight
F7
F8
F9
_
;
!
$
L
M
N
O
P
Q
R
S
@/!/o
0/$/p
(/)/q
*/#/r
SPACE/s
“/’/t
0
(
*
)
#
SPACE
“
SPACE
‘
s
t
T
,/?/u
[/]/v
//\/w
</>/x
=/&/y
DEL/z
,
[
/
<
=
DEL
?
]
\
>
&
~
u
v
w
x
y
z
U
V
W
X
Y
Z
Copyright 2008 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Turning the RH767 on for the First Time
Charge the RH767 for at least 16 hours before initial use. Once the RH767 starts,
it is time to adjust the screen brightness, calibrate the display and setup the system
time zone date and time.
1. Start the RH767 by pressing the power button on the front panel.
Using the Stylus
Never use anything other than the RH767 Stylus
on the screen.
CAUTION!
1. Remove the Stylus from its holder.
2. Hold the stylus like a pencil.
3. Lightly tap the tip of the Stylus to make a menu choice.
4.Double-tap to open programs.
5. Use the Stylus to print letters or numbers.
CopDyrigohwt 2n00l8ouanidtecfhrEolemctroWnicswCwo.,.LStdo. Amll raignhtsuraeslesrv.ecdo. umnit.ecAh ilslaMreagisnteureadltsradSemeaarkrocf huniAtecnhdEleDctroonwicsnCloo.,aLdtd..
Calibrating the RH767 Screen
The calibration screen automatically appears when the unit powers on for the first
time or after the system is reset.
Use a stylus to tap a sequence of target marks on the RH767’s screen. Firmly hold
the stylus on top of the target mark for a moment, and then remove. Continue to tap
the target mark as it stops along the corners of the screen.
Press Enter to confirm the calibration or press ESC to cancel.
CopDyrigohwt 2n00l8ouanidtecfhrEolemctroWnicswCwo.,.LStdo. Amll raignhtsuraeslesrv.ecdo. umnit.ecAh ilslaMreagisnteureadltsradSemeaarkrocf huniAtecnhdEleDctroonwicsnCloo.,aLdtd..
Setting the Time and Date
In the Date/Time Properties window, use the stylus to select the current date and
time, time zone and daylight saving time option.
Adjusting the Screen Brightness
Adjust the screen brightness by pressing Func to enable the soft key function and
press the left arrow (decrease brightness) or right arrow (increase brightness) cursor
buttons.
Function Button
Increase Brightness
Decrease Brightness
CopDyrigohwt 2n00l8ouanidtecfhrEolemctroWnicswCwo.,.LStdo. Amll raignhtsuraeslesrv.ecdo. umnit.ecAh ilslaMreagisnteureadltsradSemeaarkrocf huniAtecnhdEleDctroonwicsnCloo.,aLdtd..
|