Contents
02 Introduction
03 General Information and Safety Instructions
05 Assembly and Parts List
07 Getting Started
10 Other Useful Information
12 Warranty Card
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
General Information & Safety Instructions
3
When using an electrical appliance, basic safety precautions should also be observed, including the
following. PLEASE READ AND SAVE ALL INSTRUCTIONS BEFORE USING THE CARPET CLEANER.
1. Do not leave Carpet Cleaner when plugged in. Unplug from outlet when not in use and before
servicing.
2. To reduce the risk of electric shock – use indoors only.
3. Do not allow this to be used as a toy. Close attention is necessary when used by or near children.
4. Use only as described in this manual. Use only manufacturer’s recommended attachments.
5. Do not use with a damaged cord or plug. If Carpet Cleaner is not working as it should, has been
dropped, damaged, left outdoors, or dropped into water, return it to a service center.
6. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp
edges or corners. Do not run Carpet Cleaner over cord. Keep cord away from heated surfaces.
7. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
8. Do not handle plug or Carpet Cleaner with wet hands.
9. Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint,
hair and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
11. Turn off all controls before unplugging.
12. Use extra care when cleaning on stairs.
13. Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where
they may be present.
14. To reduce the risk of fire – Do not use a flammable or combustible liquid to clean a floor.
15. This Carpet Cleaner is provided with double insulation. There are no user serviceable parts. Return
to warranty center for repair or replacement.
16. Do not attempt to remove water tanks while the Carpet Cleaner is running.
17. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
18. Do not use abrasive materials to clean the Carpet Cleaner. Do not immerse the Carpet Cleaner in
water.
19. Do not use on concrete, tar or similar rough surfaces.
20. Do not pick up pieces of string or fabrics with the Carpet Cleaner.
21. Do not clean tasseled or frayed carpets with the Carpet Cleaner.
22. Do not use the Carpet Cleaner without water tanks in place.
23. Store the Carpet Cleaner indoors. Store after use to prevent accidents.
24. Read and follow all operational instructions.
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY.
SAVE THESE INSTRUCTIONS
3
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
Servicing of Double Insulated Appliances
A double insulated appliance is marked with one or more of the following: The words “DOUBLE
INSULATION” or “DOUBLE INSULATED” or the double insulation symbol (square within a square).
In a double-insulated appliance, two systems of insulation are provided instead of grounding. No
grounding means is provided on a double=insulated appliance, nor should a means for grounding be
added to the appliance. Servicing a double-insulated appliance requires extreme care and
knowledge of the system and should be done only by qualified service personnel. Replacement parts
for a double-insulated appliance must be identical to the parts they replace.
THIS APPLIANCE HAS A POLARIZED PLUG (ONE PIN IS WIDER THAN THE OTHER) TO REDUCE THE RISK OF
ELECTRICAL SHOCK. THIS PLUG IS DESIGNED TO FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF THE PLUG
DOES NOT FIT FULLY INTO THE OUTLET, TRY THE PLUG THE OTHER WAY AROUND. IF THE PLUG STILL DOES NOT
FIT, CONTACT A QUALIFIED ELECTRICIAN. DO NOT ATTEMPT TO ALTER, DISMANTLE OR FIND ANOTHER WAY
AROUND THIS SAFETY FEATURE.
WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result
in electric shock, fire or serious personal injury. The warnings, cautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are a factor which cannot be built into
this product, but must be supplied by the operator.
ELECTRIC POWER
If electric circuit is overloaded with other appliances, your Carpet Cleaner may not operate properly.
The Carpet Cleaner should be operated on a separate electrical circuit from other operating
appliances.
SAFETY WARNING
Although your Carpet Cleaner is easy to operate, for your safety, the warnings below must be followed:
1. Do not place the Carpet Cleaner near a heat source.
2. Do not unplug by pulling on the power supply cord.
3. The Carpet Cleaner must be unplugged:
A. Before any cleaning or maintenance.
B. If it appears to be faulty.
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY.
SAVE THESE INSTRUCTIONS
4
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
5
Assembly and Parts List
Main Parts
1
2
14
3
4
13
5
6
10
9
7
12
11
8
1. Handle
8. Brush Bar
9. Dirty Water Tank
10. Dirty Water Tank Handle
11. Handle Release Pedal
12. Lower Power Cord Holders
13. Power Cord
2. Solution Release Trigger
3. Clean Water Release Button
4. Clean Water Tank
5. Power Switch
6. Dirty Water Tank Latch
7. Exhaust Filter
14. Upper Power Cord Holder
Contents of Packaging
1. Handle
2. 2 X Screws
3. Carpet Cleaner Body with Water Tanks attached
4. Instruction Manual
5
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
If any of the above items are missing, please contact our customer service department at
business hours are Mon-Fri 9:00 AM - 4:00 PM CST.
ASSEMBLY
Insert handle into the Carpet Cleaner. Insert a screw into the hole on each
side of the handle. Tighten screws.
Helpful Things to Think About Before Carpet Cleaning:
Before cleaning, determine where to start and end, making sure not to walk over previously
cleaned area.
Do not over saturate carpet with cleaning solution while using Carpet Cleaner.
For heavily soiled areas, additional applications may be necessary.
Allow plenty of time for carpet to dry completely.
Wipe cleaning solution from woodwork and wood to prevent damage
6
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
7
Getting Started
BEFORE FIRST USE
IMPORTANT: Do not use the Carpet Cleaner as a dry vacuum.
Vacuum the carpet thoroughly.
Remove as much furniture from the room as possible. If unable to remove the furniture, place
plastic or foil under and around furniture legs until the carpet has completely dried.
Check for Color Fastness:
Before cleaning carpet, test for color fastness. Dampen a white cloth with carpet solution. Test a
small area in an inconspicuous place. Gently rub over the area. Check each color for color
bleeding. If the cloth remains clean, it should be safe to clean the carpet.
PREPARING THE CARPET CLEANER
Hold the handle of the clean water tank and press
“Clean Water Tank Release”. Tilt clean water tank
away from the Carpet Cleaner and remove.
Unscrew the tank cap from the bottom of the water
tank and fill with 2 teaspoons of cleaning solution.
Fill the remainder of clean water tank with warm tap
water to the MAX line. Replace cap.
Place bottom of clean water tank into the Carpet
Cleaner and push back until it locks into place.
NOTE: Any carpet cleaner solution available at your local retail or hardware store can be used
with this Carpet Cleaner. Please note you may need to modify the amount of cleaning solution
you use.
Plug cord into electrical outlet. Turn on the Carpet Cleaner by using the on/off switch
located on the side of the machine.
IMPORTANT: Never leave unit unattended with power on. Turn off before emptying and filling tanks.
Do not over saturate the carpet.
7
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
Step onto the handle release pedal to put the Carpet Cleaner into cleaning position (Fig. 1).
While depressing the solution release trigger (Fig. 2), pull Carpet Cleaner in a backward
motion. Release the trigger and push the unit forward in the same path to agitate and remove
dirty water and solution from the carpet.
NOTE: For heavier soiled areas repeat if necessary.
Fig 2
Fig. 1
IMPORTANT: For best results use a steady, moderate, forward and backward motion (about 1
second per square foot.) Always work from back to front across the room to avoid stepping on wet
carpet and lowering pile.
When dirty water tank is full, lift water tank latch (Fig. 3) and remove from base using handle.
Twist dirty water tank outlet cap to the left and remove, empty, rinse and replace (Fig. 4).
Fig. 4
Fig. 3
When finished cleaning, remove both dirty and clean water tank and rinse with warm water
and allow to dry before storage.
Remove exhaust filter, rinse with warm water and allow it to dry thoroughly before storing
(Fig.5).
Fig. 5
IMPORTANT: Do not use any chemicals on the carpet when cleaning. ONLY use store bought
carpet cleaner solution.
8
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
After Cleaning:
Allow carpet to dry completely. Try not to walk on the carpet until thoroughly dry.
If it is necessary to walk on the carpet, place white towels on the floor before walking on the
carpet.
If the carpet is not dry and the furniture must be placed back into the room, use plastic or foil
under the furniture to prevent staining the carpet.
Thoroughly clean the dirty water tank with warm tap water.
After carpet is completely dry, vacuum the carpet using a vacuum cleaner with revolving
brush.
9
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
10
Other Useful Information
Technical Specifications
Model Number
Rating Voltage
Rated Wattage
Maximum Capacity
VC9385S
120V – 60Hz
600W
of Clean Water Tank 6 cups
Maintenance
CAUTION: Always be sure that the Carpet Cleaner is turned OFF and UNPLUGGED before
removing the water tanks, exhaust filter, and cleaning.
DO NOT use abrasive cleaners to clean any part of the Carpet Cleaner.
1. When finished cleaning, remove the clean and dirty water tanks.
2. Rinse the water tanks with warm water and allow them to dry thoroughly before
storage.
3. Remove exhaust filter (Fig. 5), rinse with warm water and allow it to dry thoroughly
before storing.
Storing
1. DO NOT store the Carpet Cleaner with solution in clean water tank or dirty water in the
dirty water tank. Mineral deposits and mildew can form and will affect the
performance of the Carpet Cleaner.
2. Store the appliance in a dry location.
3. Do not place any heavy items on top of the Carpet Cleaner or hang it by the handle.
This could result in possible damage of the Carpet Cleaner.
CAUTION:
Any electronic or electrical appliance should not be stored in or exposed to areas of high
heat or humidity. Do not store your Carpet Cleaner close to stoves, radiators, furnaces, or
in a bathroom or bathing area.
10
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
Service Center
If you have any questions in regards to the operation of this Stick Vac please contact our
service center at:
Wachsmuth & Krogmann, Inc.
(Business hours Mon - Fri 9:00 AM - 4:00 PM CST)
Environmental Protection
If the appliance should no longer work at all, please make sure that it is disposed of in an
environmentally friendly way.
11
AFTER SALES SUPPORT
1 888 367 7373
03-12-14 / VC9385S
|