3D Connexionr S201 User Manual

RODUC T NFORMATION ULLETIN  
P
I
B
Bulletin # 273804  
DVR-S201 – Upgrade to 2.00 Firmware  
BACKGROUND  
The original DVR-S201 DVD Recordable drive was released with the trial version 1.9 firmware. To comply with  
the DVD Forum’s specifications for authoring uses, Pioneer is providing a firmware upgrade, version 2.0, for this  
drive.  
Due to security reasons, you must register your drive with Pioneer to download the new version. By registering the  
drive, you will receive firmware upgrade notifications as they become available.  
DETAILS  
Download Utility  
Go to the Pioneer New Media website, http://www.pioneerusa.com, and select Recordable Drives under  
the DVD/Optical Products section. Scroll down to DVR-S201 Firmware Upgrade.  
If the file is unavailable from the website, please access the following webpage to register your drive.  
To register a drive, please have the following information available:  
Serial Number(s) [up to five units may be registered at a time]  
Date of Purchase  
Vendor Name  
City and State where purchased  
Operating System supporting the drive  
General usage information  
Follow the instructions below to register your drive(s).  
1) Enter the following drive information:  
* serial number(s) [maximum 5 drives per entry sequence]  
* date of purchase  
* vendor name  
* city and state where purchased  
2) Enter the following personal information:  
* your name  
* company  
* job title  
* address with city, state and zipcode  
* phone number  
* email address  
3) Select the appropriate Operating System (supporting the DVR-S201 drive).  
Page 1 of  
3
Pioneer New Media Tec hnologies, Inc ., Produc t Development & Tec hnic al Support  
(310) 952-2111  
 
RODUC T NFORMATION ULLETIN  
P
I
B
Bulletin # 273804  
4) Press Y on the keyboard while the drive is OFF.  
5) Turn the DVR-S201 drive back ON.  
6) Look for the message, “The DVR-S201 has been updated correctly to ver2.00.”  
7) Press the spacebar on the keyboard to exit the program and reboot the computer.  
Failed Upgrade  
The upgrade is complete although the PC failed to ‘see’ the drive. If a Drive Not Found message appears  
after rebooting the system, shut down the system then power it up again. Rebooting clears the message.  
Launch the drive software and check the version level in the properties window. Shut down the program  
after checking the version.  
To check the drive firmware version using the bundled application, Crosswriter, follow the instructions  
listed below.  
1) Launch the Crosswriter program.  
2) Select Information from the main menu.  
3) Click on Version.  
4) Confirm that the firmware version is 2.00.  
Page 3 of  
3
Pioneer New Media Tec hnologies, Inc ., Produc t Development & Tec hnic al Support  
(310) 952-2111  
 

Aastra Telecom Telephone 55I IP User Manual
Acer Laptop 1800 Series User Manual
AEG Cooktop HG654440SM User Manual
AEG Refrigerator SCS51400S0 User Manual
Aero Mist Fan 67014 User Manual
Aga Ranges Range EC LM 2 User Manual
Agilent Technologies Computer Accessories N5700 User Manual
A T International Cordless Telephone CL82101 User Manual
Bakers Pride Oven Fryer FKM User Manual
BK Stereo Amplifier 1255 S2 User Manual