Aspire Digital eBook Reader version 120 User Manual

Aspire System Boot Code Update Instructions  
Use the following instructions to update the Aspire system’s boot code. This code provides basic start-up  
functionality for the Aspire.  
Compatibility  
Though the Boot Code version 1.20 can be used with any system software, when used with software 1.21 or  
higher, the VRS feature will work with any version of the Aspire NTCPU. With Boot Code prior to 1.20, for  
the VRS feature, the NTCPU has to be either:  
G
The 64-Port Basic NTCPU (P/N 0891002) with the Feature Upgrade PAL chip (P/N 0891039)  
OR  
G
The Enhanced NTCPU (P/N 0891038)  
Note that the VRS feature requires a DSPDB be attached to the NTCPU with the optional VRS flash card  
installed. Although the DSPDB is recognized for this feature, it will not provide any additional tone resources  
(DTMF receivers, Caller ID receivers, or call progress tone detection).  
Updating the System Boot Code  
1. Turn the system power off by pressing the power  
button on the power supply in the PS1 slot (this  
controls power to both power supplies if there are  
two installed in the cabinet). If there are two cabi-  
nets connected, turn off the power to the expan-  
CN15  
sion cabinet, then the power to the main cabinet.  
LAN Connector  
CN6  
EXIFU  
(connector)  
PCB Status LED  
(on back of PCB)  
2. Insert the NTCPU Boot Code Master Flash Card  
Operating  
Status LEDs  
(on back of PCB)  
into the PCMCIA Card slot (CN11) on the NTCPU.  
3. Set both levers of the Boot Device Selection  
switch (SW3) to the "ON" position.  
CN11  
PCMCIA Slot  
USB Connector  
SW1 Load Switch  
4. Connect a PC to the NTCPU card using an RS-  
232C cross-over cable by connecting to the RS-  
232 port of the PC to the RS-232 connector (CN1)  
on the NTCPU.  
5. Run the HyperTerminal communication program  
from the PC and change the settings as follows:  
SW2 Reset Switch  
CN10  
DSPDB Connector  
SW3 Boot Device  
Selection  
+
CN1 Serial  
D-Sub 9-Pin  
Connector  
CN17 Night Mode  
External MOH  
Control  
CN14 PAL Connector  
G
Connection: COM Port  
Bit/Sec: 38400  
Data Bit: 8  
Parity: none  
Stop Bit: 1  
Flow Control: Hardware  
CN16 External MOH  
Input, Audio Output,  
BGM Input  
G
G
CN12 Battery  
for Memory Backup  
G
G
G
6. Turn on the power to the KSU by pressing the power button on the power supply in the PS1 slot.  
7. The Boot Code will automatically be updated once the system is powered up.  
Confirm that the display appears as shown in the figure which follows.  
- Over -  
 

ADC Switch Miniature Series User Manual
Addonics Technologies Blu ray Player DGBRC1 User Manual
AEG Saw TKS CS User Manual
Air King Fan 4TM63C 9420C User Manual
Alpine Universal Remote RUE 4191 User Manual
Altec Lansing Speaker FX6021 User Manual
Altec Lansing Speaker iMmini User Manual
Amana Range W10181330A User Manual
Asus Computer Hardware V7100 User Manual
Atlona Webcam AT HD580 User Manual